What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
10.06.2025 15:19

At least they know the answer if they wanted it.
One is “what exactly is in a ‘surge protector’ ? ”
At one ohm, the resistor has a maximum of 1 watt power.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Here is a simplified AC power diagram.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Europe cuts interest rates as Trump's tariffs loom - BBC
For this case there are devices called Metal oxide varistors (MOV).
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
so, what happens?
Skulls once subject to racist study in Germany are laid to rest in New Orleans - NPR
Upvotes:
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Speech by Governor Kugler on the economic outlook and monetary policy - Federal Reserve Board (.gov)
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Because the load is inductive, the current lags the voltage.(by a bit).
But it can get overloaded, and no longer works.
What is lightning?
VMware drops the lowest tier of its partner program – except in Europe - theregister.com
2024–10–14 [Omar Gharbi Omar Gharbi ]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
How corporate America learnt not to mess with Texas - Financial Times
The MOV will conduct when the voltage exceeds 50% of line voltage.
[old diagram got deleted by accident]
This is where this question deviates from being a 'generic' question, and becomes more specific.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This is where the MOV conducts again, and dissipated the energy.
This is 'the assistant's answer'
'Orthorexia' Is More And More Common. Here's What You Should Know About It. - HuffPost
These are simplified answers to the original question, and does not change anything I wrote above.
Edit 2024–10.
One
First Sentence:
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
A circuit breaker is similar, but is resettable.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
[image of Common-mode choke]
A fuse is a non-resetable over current circuit protector.
The third is lightning and “how it gets conducted into a home.”
These devices are installed between the “hot” and “neutral” and protective ground.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
The other is “what does a “fuse” do?”
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This device then solves the entire problem.
a photo is worth a thousand words.
but this device (an Inductor) … impedes the rapid changes in the current.
(Dc diagram shown, AC is similar).
what exactly is a ‘surge’ protector?
An AC voltage/ current source, and an ac inductive load.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
but I think this circuit , shows a few more pieces.
It also is a device that limits the change in current flow.
Barnstars:
He then describes the function of a fuse.
There are three different concepts here that are getting confused.
nine
2024–10–10[John johnson John Johnson ]
But… the neutral is now “floating” because of the 1 ohm resistance.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
There are two important concepts here.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
It seems Mohan does not understand the difference between a comment and an Answer.
eight
So, the voltage could go up to 500 volts, and the fuse will not open up.
In schematic diagrams this is the symbol for a fuse:
I post the exact comment here.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
What does a fuse do?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
2024–10–16 [ OO OLAOYE OYEBODE ]
The bolt then partially travels down the line to your home.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Now when you have a certain ac resistance, then a current flows in a loop.
He then describes Rainy Season and Lightning.
This one hit behind the barn.
the problem then depends on "how fast does the fuse operate?".
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
He then asserts :
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).